Sekonic MULTIMASTER L-408 Instructions d'exploitation télécharger pdf (Page 11)

5. Preparation for Measurement

5.1

Mounting a battery and strapping

Use a 1.5volt, type-AA (UM3 dry, LR-6 or R-6) battery. Do not use a NiCd battery.

@ Unlock the cover lock and remove the battery case cover. @ Insert the battery in

the battery case aligning the polarities as indicated on the inside of the case.

@ insert the claws of the cover into the holes of the

bodv. Lock the cover lock.

, Pull down the strap ring.

Battery

case cover

Cover lock

ICAUTION

Attaching the strap

Remove the battery case cover.

Move the cover lock toward the battery

case (arrow

a).

Pass the strap through strap eyelet

@ Pass the opposite side of the strap through

a strap ring.

l To save your current setup, turn the POWER switch OFF first, then

replace the battery.

e If the LCD message is abnormal or if nothing occures when you press

an operation button, remove the battery. Wait at least 10 seconds.

Then, mount the battery (in the correct polarity) and try again.

l Wipe and clean the rubber seal of battery cover. Sand and dust may

cause water leakage, corrosion or other problems.

5.2 Battery check

Turn the POWER switch on, and the LCD panel

(“b.c”

message and bar marking 2‘:“; ) displays

the current battery level. The battery level is

indicated by a number of bars for one second.

Then, the LCD panel automatically switches to the

normal measurement mode.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 26 27

Pas de commentaire

Sekonic MULTIMASTER L-408 Instructions d'exploitation Page 11