Sekonic DIGI LITE F L-328 Instructions d'exploitation Page 1

SEKONIC DIGI LITE F L-328 Operating Instructions

Post-Measurement Calculation 1. By changing ISO sensitivity the measured F-stop value will automatically be altered to the appropriate one corres

Contrast Metering for Lighting Balance When calculating a desired lighting balance, the meter can be used to measure thebrightness of main and fill-in

Illuminance (LUX) Measurement The meter can be used as a LUX meter when used with the Lumidisc in the ambient lightmeasuring mode.1. Mount the Lumidi

Accessories Lumisphere • Use the Lumisphere when you wish to measure incident light forportraits and three-dimensional subjects. In case of incident l

Specification Measuring system • Incident and reflected light measurement Flash light for wireless and wired, and ambient light measurements Meas

Care of Your Meter DIGI LITE F meter is a high-precision instrument containing delicate electronic parts and components, and you are recommended to ha

SEKONIC CORPORATION 7-24-14, OIZUMI-GAKUEN-CHO, NERIMA-KU, TOKYO 178-8686, JAPAN TEL:(03)3978-2335 FAX: (03)3978-5229 T19134OB-A

Parts Designations Lumisphere Swivel Head (270° rotatable) Liquid crystal display Measuring switch Power switch UP/DOWN key Mode selection switch ISO

Liquid Crystal Display (1) (2) (3) - By pressing F/W key, the indicated symbol will be converted from F to EV, and vice versa. When t

Preparing the Meter for Operation 1. Inserting the battery The meter uses a single AA size pen-light battery (1.5h. Open the battery chamber cover by

44. Setting ISO sensitivity Press either side of UP/DOWN key while holding ISO key depressed so that the ISO number of your film is displayed.

2. Set the film speed (ISO) and shutter speed (T) as shown in the paragraph for "Preparing the Meter for Operation". 3. Press the measurin

Measurement using Flash Unit with Synchro Cord It is recommended that the meter is used in the wired measurement mode when the flash light is measured

Ambient Light Measurement Measuring ambient light, whether it is daylight or standard electric light, is a fairlysimple matter using either incident o

The procedures for taking measurements when using a movie camera are the same as for taking ambient light measurements. Keep depressing the UP side of