Sekonic L-758DR Manuel d'utilisateur télécharger pdf (Page 17)

-11-

4. Basic Operation

1. Incident or reflected spot measuring

1. To set for either incident or reflected light operation, turn the Incident / Reflected Spot Selector

Dial ⑲ on the eye piece, to the desired position ( or mark) until it clicks.

2. When incident operation is selected, the

mark will blink for ten seconds and when Reflected

Spot operation is selected the

mark will blink for ten seconds on the LCD.

NOTE:

• Before taking measurements, always make sure that the desired measurement mode

(

or ) is chosen by checking the LCD or that the Incident/Reflected Spot Selector

Dial is clicked in proper position.

• Do not rotate the Spot lens ring. There is danger of damage.

Incident operation Reflected Spot operation

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 67 68

Pas de commentaire

Sekonic L-758DR Manuel d'utilisateur Page 17