Sekonic FLASHMATE L-308BII Instructions d'exploitation télécharger pdf (Page 35)

5. Measurement

NOTE: ● There is a danger of electric shock if the meter is handled with

wet hands, during rain, in areas splashed by water or where

there is a lot of moisture, if you use cord flash mode.

● The electronic flash unit may trigger when you connect the

synchro cord or operate the Power button.

● For flash unit with an extremely low trigger voltage, the flash

may not fire. In this case, make measurements in auto reset

cordless flash mode. (See page 16)

● When triggering a flash bulb to take measurement, please

check the cameras synchronizing range and set the proper

shutter speed.

REFERENCE: • It is possible to switch the shutter speed between full, 1/2 or

1/3 stops by custom setting (see page 19).

• Shutter speed can be set from 1sec, 0.8sec through to 0.3 sec,

1/4 through to 1/500 sec and followed by 1/75, 1/80, 1/90 and

1/100.

• After measuring, if the shutter speed is changed, the

measurement value (aperture value) will revert to zero. In such

cases please measure again.

• If ISO film speed is altered after measuring, a calculated value

(aperture value) will be displayed.

• Even if settings are within the measurement range of the

L-308S, the E.o or E.u symbol may appear for the aperture

value corresponding to the set shutter speed.

Change the shutter speed or measure again using the following

methods.

✩ When the display range is exceeded (E.o), press the Up button y to change

the shutter speed to the high-speed side within the synchronizing range of

the camera, or lessen the quantity of flash light and measure again to display

a measurement value (aperture value).

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 44 45

Pas de commentaire

Sekonic FLASHMATE L-308BII Instructions d'exploitation Page 35