Sekonic FLASHMATE L-308BII Instructions d'exploitation télécharger pdf (Page 6)

3. Mode Selection

Your L-308Bll can measure both incident and reflected light in both ambient light and flash light

(electronic flash or flash bulb) modes. You can switch the modes as follows:

[Ligh&y.eng [Ligh$xec#ng [Measured light] [Mode/display method]

see Page 7.

3.1

Switching between incident light metering and reflected light

metering

Slide the lumisphere and stop it at the clicking position of “a” or “b” (See Fig.1 and 2).

Lumisphere

Fig. 1 Incident light metering Fig

2 Reflected light metering Fig. 3

Caution: 1

Slide the lumisphere by pushing the part as shown in Fig. 3.

3.2 How to fit the Lumidisc

Slide the Lumisphere to the right for reflected light metering.

(See Fig. 5)

@ Insert the part (B) of the lumidisc aslant in the groove (A) of L-308Bll. (See Fig. 6). Then

depress the strap eyelet (C) toward the L-308Bll body. (See Fig. 7)

umisphere

Fig. 4 Lumidisc Fig. 5 Fig. 6 Fig. 7

3.3 How to remove the Lumidisc

Take reverse procedures described above to remove the Lumidisc.

Caution:

You may break the lumidisc if you do not take care when fitting and removing,

1 2 3 4 5 6 7 8 9 10 11 ... 44 45

Pas de commentaire

Sekonic FLASHMATE L-308BII Instructions d'exploitation Page 6